Replacement of a Failed Embankment Designed to Accommodate Large Settlement: A Case Study
Thick deposits of soft, normally to slightly preconsolidated, organic clay are common at low elevations along the riverbanks of southeast Texas. Both the moisture content and liquid limit...
Performance of Oil Storage Tanks on Vibroflotation Improved Hydraulic Fill in the Port of Tampa, Florida
The paper describes a case history of design, construction and performance monitoring of two 80,000 barrel oil storage tank foundations 35 meters in diameter on a soft hydraulic fill soil...
Prediction of Settlements of Footings on Sands: Accuracy and Reliability
Serviceability limit states are controlled by the deformations that a specific structure can undergo. This aspect involves a correct design of foundations to ensure that the supported...
Finite Strain Consolidation for Vertical Drains
Consolidation equations for vertical prefabricated drains which consider finite vertical strain of the soil are derived. Estimated consolidation times are shorter when finite soil strain...
A Procedure for Predicting Seismic Deformation of Earth Structures
This paper presents an analysis procedure for predicting the earthquake induced displacements of earth structures. The procedure is an extension of the simple Newmark method from a single-degree-of-freedom...
Deformation of Sand Foundations Induced by Earthquakes
This paper discusses the deformation of sand foundations during earthquakes based on the experimental results of centrifuge tests. A group of tests was conducted on two types of buildings...
Seismic Settlement of Shallow Footings on Sands
In this contribution, the progressive seismic settlement of shallow footings on cohesionless soils is calculated using a sliding block model. Beyond a critical horizontal acceleration,...
Soil-Structure Interaction During Mining Induced Ground Movements
Mining induced subsidence can result in significant ground deformation, which is generally non-uniform. Although this deformation occurs slowly with small inertial forces, it often results...
Design and Installation of a New Settlement-Inclinometer Device
A new miniature settlement-inclinometer device (SID) system has been designed and built at the University of British Columbia for use in monitoring soft soil movements. The great advantages...
Settlement of Deep Compacted Fills in California
Measured settlement of deep compacted engineered fills from a single site were summarized and compared to data from other sites. The data indicate that the rate and magnitude of movement...
Building Performance Founded on an Improved Sand in Recife, Brazil
Studies performed on a fourteen-storey building founded on an improved sand are presented. These studies included soil profile characterization, the choice of foundation type, the ground...
Settlement of Footings on Granular Materials: Low and Large Strain Parameters
Many methods have been proposed to predict the settlement of shallow foundations on granular soils. The analysis of more than 200 case histories shows that there is no correlation between...
Deformations About Excavations in Highly Stressed Rock
The central business district of Sydney, New South Wales (NSW), is dominated by the Hawkesbury Sandstone, a Triassic sedimentary formation. Measurements have confirmed the existence of...
Tolerable Deformations
Current criteria for tolerable movements of buildings, bridges and other structures are reviewed. Tolerable values of total and differential settlement, relative rotation, relative deflection...
Stress-Deformation Behavior of an Embankment on Boston Blue Clay
An 11 m high I-95 embankment was thoroughly instrumented with piezometers, settlement rods and inclinometers to measure the behavior of the underlying 40 m thick deposit of Boston Blue...
Pressure-Time Flow Rate in Low Head Hydro Plants
Very few methods are accepted for measuring the flow in the large intakes typical of low head, run-of-the-river hydro plants. These intakes are characteristically short, non-uniform, non-prismatic,...
Non-Intrusive Experimental Setup for Inflatable Dam Models
A method which allows for a non-intrusive evaluation of the dynamic response of the inflatable dams under overflow and impounding water conditions is presented. The internal pressure variations...
Influence of a Sand Layer on Headcut Advance
The presence of an erodible material layer in the soil profile has been observed to influence headcut movement in earth emergency spillways. Large-scale flume tests were conducted to examine...
A Lagrangian Model for Surface Buoyant Jets
A model is developed to predict the trajectory of a surface buoyant discharge into a large receiving water body. A Lagrangian approach is used to trace the path of a `control volume' of...
Plunge-Pool Scour by Inclined Jets
A series of experiments were performed in a sand-bed plunge pool with circular jets produced by nozzles at different angles and elevations and conveying different flow discharges. The...
Return to search